Home

  Ento (Sales Equipment)
  31 Somers Street (Cnr of Somers & Salisbury Sts) off Berkshire Road Ph: (03) 9380 4944
  Sunshine   Vic   3020 Fax: (03) 9311 8415
  Email: [email protected]

A proud subsidiary of

B.K. Group Pty Ltd

 
 
 

heavy duty trucks & accessories


ET9

ET9 - POINTED TOE DRUM TROLLEY

The Drum trolley has a curved back and pointed toe for ease of sliding it under 200 litre drums. The frame is also fitted with a chain which can be wrapped around the drum to hold it in place, leaving both hands free to operate the trolley.

   

ETFARM "All Terrain Trolley"

ETFARM - FARMERS TROLLEY

This heavy duty frame has a curved back to take large and small drums. The straight "U" shaped sides give strength and ease of handling. The cross bars in the frame support stacked drums and add strength to the frame. The toe is made up of two heavy duty 12mm prongs to carry fence posts, boxes and bales and a cross bar to support smaller items. It is normally supplied fitted with 400mm pneumatic (wheelbarrow) wheels to allow it to be easily wheeled across rough ground.

   

ET/CHAIR

ET/CHAIR - UNIVERSAL CHAIR TROLLEY

Upright hand truck for moving stackable chairs. It is fitted with 260mm pneumatic wheels. The frame stands 1250mm high and is similar to our standard range of handtrucks but without any toe. This has been replaced by a support to locate the rear legs of the chair. In addition, the trolley has a front leg fitted with 2 X 75mm wheels to allow for easy pick up of stacks without damage to the floor surface. This also supports the trolley in the upright position. To lift the chairs, there are arms which extend approximately 350mm and are 200mm wide. These are fitted with rubber to protect and support chairs during lifting. These fit under the chair and are adjustable in height between 290mm and 490 mm to suit a range of chair designs.

   

ET/RAT

ET/RAT - RATCHET STRAP

The safety ratchet is equipped with a seatbelt web strap and metal hook. It can be fitted to the centre bar of the Appliance or Refrigerator trolley to hold tall or heavy items in place and can be slid up and down as required.

NOTE: The ratchet strap is available if requested but not fitted as standard.


DISCLAIMER

The information shown in this document, including designs and related materials are the property of    Ento (Sales Equipment), or in the case of distributed products, the property of the original designer.  The details given herein are accurate to our knowledge.  Recommendations relating to the use of products are based on our experience and should not be taken as a guarantee of suitability.   In no event will Ento (Sales Equipment) be held liable for damages, lost profits or other special, incidental, consequential or indirect damages arising from the use of any of these products.   The information in this brochure is subject to change without notice.